Start-Up; Password Setting In P0000 - WEG CFW11W G2 Series User Manual

Energization and Start-Up
15. Mechanically uncouple the motor from the load.
If the motor cannot be uncoupled, make sure that any speed direction (forward or reverse) will not result in
personnel injury and/or equipment damage.
16. Command the drive, pre-charge the link and close the main circuit breaker/contactor.
17. Check the success of the energization.
18. The display must show the standard monitoring screen
turn on and remain on in green.

5.2 START-UP

The start-up in the V/f mode is simply explained in three steps, using the programming facilities with the existing
parameter groups Oriented Start-Up and Basic Application.
Sequence:
5
1. Set the password to change parameters.
2. Execution of the Oriented Start-Up routine.
3. Setting the parameters of the Basic Application group.

5.2.1 Password Setting in P0000

Step Action/Result
1 - Monitoring mode
- Press "Menu" (rigth soft
key)
2 - Group "00 ALL
PARAMETERS" is already
selected
- Press "Select"
3 - Parameter "Access to
Parameters P0000: 0" is
already selected
- Press "Select"
4 - To set the password, press
the Up Arrow
number 5 is displayed in the
keypad
5-2 | CFW-11W G2
Display Indication
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
15:45 Menu
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
Access to Parameters
P0000: 0
Speed Reference
P0001: 90 rpm
Return 15:45 Select
Ready 0rpm
LOC
until
P0000
Access to Parameters
0
Return 15:45 Save
Figure 5.1: Sequence for allowing parameter change via P0000
(Figure 4.3 on page 4-3
Step Action/Result
5 - When number 5 is
displayed in the keypad,
press "Save"
6 - If the setting has been
properly performed, the
keypad should display
"Access to Parameters
P0000: 5"
- Press "Return" (left soft
key)
7 - Press "Return"
8 - The display returns to the
monitoring mode
(a)), the status LED must
Display Indication
Ready 0rpm
LOC
P0000
Access to Parameters
5
Return 15:45 Save
Ready 0rpm
LOC
Access to Parameters
P0000: 5
Speed Reference
P0001: 90 rpm
Return 15:45 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
15:45 Menu