Typical Drives - WEG CFW11W G2 Series User Manual

Installation and Connection

3.2.12.4 Typical Drives

Drive 1 - Run/Stop function with control via HMI (Local Mode).
With the factory default programming, it is possible to operate the inverter in the local mode. This operating mode
is recommended for users that are using the inverter for the first time, as a form of learning.
In order to perform the start-up in this operating mode, refer to
page 5-1.
Drive 2 - Run/Stop function with two-wire control (Remote Mode).
3
Valid for factory default setting and inverter operating in the remote mode. In the factory default, the selection of
the operating mode (local/remote) is done by the key
In order to change the default setting of the key
3-38 | CFW-11W G2
LOC
REM
LOC
to remote, set P0220 = 3.
REM
H
≥5 kΩ
AH
Start/Stop
Forward/Reverse
(FWD/REV)
Jog
Figure 3.45: Connections in XC1 for Drive 2
Chapter 5 ENERGIZATION AND START-UP on
(default local).
Conector XC1
1 + REF
2 AI1+
3 AI1-
4 - REF
5 AI2+
6 AI2-
7 AO1
8 AGND (24 V)
9 AO2
10 AGND (24 V)
11 DGND *
12 COM
13 24 Vcc
14 COM
15 DI1
16 DI2
17 DI3
18 DI4
19 DI5
20 DI6
21 NF1
DO1
22 C1
(RL1)
23 NA1
24 NF2
DO2
25 C2
(RL2)
26 NA2
27 NF3
DO3
28 C3
(RL3)
29 NA3