Tracking Adjustment (Pistol Grip) - Toro 30284 Service Manual

2. Lengthen the control rod if the tire is turning in
reverse and shorten the rod if the tire is turning
forward.
3. Rotate the rod several turns if the tire is rotating fast.
Then, adjust the rod in 1/2 turn increments.
4. Place the clevis pin into the drive lever (Fig. 0773).
5. Release and engage neutral lock checking that the
tire does not rotate (Fig. 0774). Continue adjusting
until the tire does not rotate.
B
A
H
G
Fig 0774
A. Handle
B. Neutral lock
C. Handle
D. Neutral lock slot
Floating Deck Mid-Size Service Manual
C
D
E
F
fi g. 53 G001732
E. Neutral position
F. Drive lever
G. Full speed forward
H. Control rod
6. Install the hairpin cotter pin between the drive lever
and the neutral lock and into the clevis pin (Fig.
0773).
Note: Make sure the clevis pin is inserted into the
neutral lock.
7. Repeat this adjustment for the opposite side.

Tracking Adjustment (Pistol Grip)

1. Remove machine from any jack stands.
2. Check the rear tire pressure. Refer to Specifi cations
for proper tire pressure.
3. Start and run the machine. Observe the tracking on
a level, smooth, hard surface such as concrete or
asphalt.
4. If the unit tracks to one side or the other, turn the
quick track knob. Turn the knob right to steer right
and turn the knob left to steer left (Fig. 0775).
Fig 0775
A. Quick track knob
LINKAGE
A
fi g. 54 G001523
4-129
4