Toro 30284 Service Manual page 234

Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
• Use jack stands when supporting machine.
• Do not use hydraulic jacks.
1. With the machine on jack stands, place the speed
control lever in the neutral position.
2. Hold the OPC levers down.
Note: The OPC levers must be held down whenever
the speed control lever is out of the neutral
position or the engine will kill.
Floating Deck Mid-Size Service Manual
!
!
3. Adjust the left and right neutral stud until the clevis
pin in the yoke touches the back end of the slot in
the control arm (Fig. 0772).
A
E
H
Fig 0772
A. Neutral control linkage E. Slot in control arm
B. Yoke
C. Neutral stud
D. Nut
LINKAGE
C
G
D
B
F
fi g. 51 G001969
bracket
F. Celvis pin
G. Spring
H. Back end of slot
4-127
4