Temporary Neutral Stud Adjustment - Toro 30284 Service Manual

LINKAGE
9. Check the travel of the shift lever in the control panel
slot. The shift lever travel should be approximately
centered in the control panel slot (Fig. 0765).
D
E
4
A. Actuating tab
B. 1/8" - 1/4" (3 - 6mm)
space
C. Safety switch
10. If needed, adjust the swivel on the speed control rod
to center the shift lever travel (Fig. 0764).
11. With the speed control lever in the neutral position,
check to make sure the safety switch is depressed
and there is 1/8" to 1/4" (3 to 6mm) space between
the actuating tab and the safety switch (Fig. 0765).
12. To adjust the switch location, loosen the two neutral
bracket screws holding the switch plate to the frame
(Fig. 0765).
13. Adjust the switch up or down to obtain 1/8 to 1/4 inch
(3 to 6 mm) space (Fig. 0765).
14. Tighten the two neutral bracket screws holding the
switch plate (Fig. 0765).
4-122
A
B
Fig 0765 fi g. 45 G001964
D. Switch plate
E. Neutral bracket
screw (2)

Temporary Neutral Stud Adjustment

Note: Perform the following procedure on both the
left and right side.
1. Move the left and right neutral lock latches to the
unlatched position.
2. Move the speed control lever to the neutral position
(Fig. 0766).
B
C
D
A
E
A. Speed control lever
B. Full speed position
C. Neutral position
Fig 0766 fi g. 43 G001962
D. Medium speed position
E. Control panel
Floating Deck Mid-Size Service Manual
C