Navigating From The User Interface - Ametek 241CE II Operator's Manual

Navigating From the User Interface

While working from the User Interface, there are four modes of operation
that you can access to view or change system information, parameters, or
variables.
While working from the User Interface, the following rules apply:
• In RUN mode and Stat\History mode, system information and pa-
rameters can only be viewed (they cannot be changed).
• After locating a main menu item, press  repeatedly to cycle through
the parameters associated with that menu.
• The software will revert back to the RUN menu if no buttons are
pressed within 2 minutes.
• Displayed values can be negative or positive. If the value is negative, '-'
will precede the value.
• In ApplicCFG or MonitorCFG mode, parameters or variables can
be viewed and/or changed (passwords are required to enter these
modes).
• While working from the ApplicCFG or MonitorCFG mode, you can
make changes to as many parameters as you like before exiting the
screen.
• While working in the ApplicCFG and MonitorCFG menus, use the
'+' button to scroll through the various options for each sub-menu
item and to select an option.
• All value and selection changes under the ApplicCFG and Monitor-
CFG menus do not take effect until  is pressed to move to the next
item or  is pressed to move to a different main menu level. If config-
uration changes are not saved to the onboard EEPROM, the analyzer
will revert to the original settings following a system reset or power-
up.
• All configuration parameter changes which need to be permanent can
be saved to the onboard EEPROM. To permanently save any configu-
ration changes, press  to scroll to the "Save AppCFG?" (or "Save
AppCFG?") prompt and then press the '+' button to answer Yes.
|
User Interface 4-5