Spare Analyzer Fuses; Replacement Boards - Ametek 241CE II Operator's Manual

Spare Analyzer Fuses

AMETEK recommends having on-site spare fuses used in the analyzer.
These fuses do not need to be changed out at regular intervals, but are
necessary in the event that a fuse has blown and a replacement is re-
quired.
When ordering replacement fuses, note the different ratings and Part
Numbers for the ATEX and CSA Certified Units for the Solenoid fuse; all
other fuses are the same for both units.
Description (Location * )
Solenoid (F1)
ATEX:
(Fuse, Time Delay 5 x 20 mm CCC)
CSA:
(Fuse FST 250 V S/B 5 x 20 mm)
Logic Power Supply (F2)
(Fuse SPT 250 V CSA and VDE,
5 x 20 mm)
Cooler Power Supply (F3)
(Fuse SPT, 250 V CSA and VDE,
5 x 20 mm)
Fuses located on terminal strip (on Termination board) near the top of the Electronics Enclosure (see Fuse rating/locations
drawing in Chapter 6).

Replacement Boards

If you require replacement boards for the Model 241CE II Analyzer, use
the following part numbers.
Printed Wiring Boards
Part No. Description (Location)
100-1181 Microcontroller Board (Door Housing, Electronics Enclosure)
100-1187 Termination Board (Electronics Enclosure)
100-0665 Optical Collar Flex Board (Detector (Measuring Cell) Assembly)
100-0666 Cooler Flex Board (Detector (Measuring Cell) Assembly)
100-0650 Non-Isolating I/V Daughter Board, optional (Electronics Enclosure)
100-0651 Isolating I/V Daughter Board, optional (Electronics Enclosure)
Recommended fuses include:
120 V
Part No. Fuse Type
301-1278 0.2 A
300-9244 1.0 A
300-6254 2.0 A
300-6256 6.3 A
240 V
Part No. Fuse Type
301-1277 0.1 A
300-9244 1.0 A
300-6254 2.0 A
300-6256 6.3 A
Qty
1
1
1
1
1
1
|
Service and Parts 7-5