Viewing Current Alarm Messages - Ametek 241CE II Operator's Manual

6-40 | Model 241CE II Hydrocarbon Dewpoint Analyzer

Viewing Current Alarm Messages

If any alarms have been detected by the analyzer, the corresponding LED
on the User Interface will be On. Any current alarm messages can be
viewed from the SCode or XSCode sub-menus.
To view the current status of alarm messages (SCode or XSCode) detected
by the diagnostics function:
1. From the RUN menu, press  once to view the Stat\History main
menu screen.
2. Press  repeatedly until you are viewing the SCode screen.
If you wish to view the XSCode, press  again.
3. To view the primary status codes from either screen, press the '+' or
'–' button.
If the alarm is current, its description will be displayed next to its asso-
ciated error code number (e.g., "3 w No HC DP"). If the alarm condi-
tion does not exist, "OK" appears next to its associated number (e.g.,
"SCode.# OK", where '#' is the error code number corresponding
with the SCode message).
4. To back out of either of these screens, press  if you wish to view oth-
er Stat\History sub-menus, or press  to go to another main menu.