Recommended Preventive Maintenance Spare Parts; Model 241Ce Ii Analyzer (120 / 240 Vac) Spare Parts - Ametek 241CE II Operator's Manual

Recommended Preventive Maintenance Spare Parts

7-4 | Model 241CE II Hydrocarbon Dewpoint Analyzer
This section lists the recommended spare parts to have readily available
for the Model 241CE II Analyzer to ensure the analyzer and its sample
system operate at peak efficiency.

For drawings that illustrate the location of all spare parts in the ana-
lyzer, see "Preventive Maintenance" in Chapter 6.
NOTE
Content is subject to change without notice.

Model 241CE II Analyzer (120 / 240 VAC) Spare Parts

The replacement of these parts is required as part of the Analyzer Preven-
tive Maintenance Schedule (Chapter 6). It is also necessary to have these
parts on hand in case the parts become damaged or contaminated, and
need to be replaced earlier than the recommended schedule.
Part No. Description
‡
100-2605 Peltier Cooler Assembly Repair Kit
Kit includes:
- Peltier Cooler Assembly (100-1578)
- Thermalcote II, 1 Tube (301-1078)
300-4511 O-Ring, EPR-218
(WX-14346) (Measuring Cell)
100-1848 Filterblock Assembly Rebuild Kit
(100-1207) (See Note *)
300-6245 Flow Restrictor, 50cc/min
(100-1207) (Filterblock Assembly)
300-4512 Flame Arrestor, 250cc/min
(100-1207) (Filterblock Assembly)
This Kit is required for maintenance on the Peltier Cooler Assembly, which is discussed in a separate
‡
document entitled Model 241CE II Analyzer Peltier Cooler Assembly Replacement Manual Supplement. To
order these Kit parts individually, use the corresponding spare part number.
 * Typically, the Filterblock Assembly requires cleaning every six
months and certain parts in this assembly should be replaced annu-
NOTE
ally. If, at the six-month cleaning interval, the Membrane Filters,
o-rings, or Flow Restrictors are found to be damaged or contaminated,
replace the parts.
1-Year Qty 2-Year Qty
0 1
3 6
1 2
0 1
0 1