Table of Contents
Advertisement
4. Connect the intrusion switch cable to the connector on the rear I/O board.
Figure 118. Installing the intrusion switch module
Next steps
1.
Install the expansion card
2. Follow the procedure listed in
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Open the blue latch to disengage the OCP card.
2. Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
3. Slide the OCP card out of the slot on the system.
158
Installing and removing system components
riser.
After working inside your system
Safety instructions
Before working inside your system
riser.
on page 47.
on page 46.
on page 47.
Advertisement
Table of Contents
