Removing The Optional Idsdm Or Vflash Card; Installing Optional Idsdm Or Vflash Card - Dell EMC PowerEdge R240 Installation And Service Manual

Removing the optional IDSDM or vFlash card

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. If you are replacing the IDSDM/vFlash card,
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into
the corresponding slots.
Steps
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Next steps
NOTE: If you are replacing the IDSDM or vFlash module, remove the MicroSD cards.
1. Replace the IDSDM/vFlash module.

Installing optional IDSDM or vFlash card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. Locate the IDSDM/vFlash connector on the system board. To locate IDSDM/vFlash connector, see
and connectors section.
2. Align the IDSDM/vFlash card with the connector on the system board.
3. Push the IDSDM/vFlash card until it is firmly seated on the system board.
Figure 57. Installing the optional IDSDM or vFlash card
60 Installing and removing system components
Safety instructions.
Before working inside your
remove the MicroSD
Safety instructions.
Before working inside your
system.
cards.
system.
System board jumpers