Setting The Acceleration - GRAPHTEC LABERLROBO DLC1000 User Manual

Setting the Acceleration

Set the acceleration of the tool that is used in each of the tool condition numbers.
Setting range: 1 to 3
Operation
1
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION (
CONDITION (The selected item is highlighted.). Then, press
Cond No. selection screen is displayed.
3
Press the POSITION (
4
Press the POSITION (
setting value.
5
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
It will return to READY screen.
) keys to select the CUT
) keys to select the ACCEL.
) keys to increase or decrease the
2-64
Supplement
Settable range is 1 to 3.
When the value is reduced, the acceleration is
lower and the quality is better.