Table of Contents
Advertisement
CAUTION
How to Improve Weedability
To improve the weed performance, please note the following.
•
Select the correct blade for the application.
Refer to the Cutter Blade Manual (supplied with the cutter unit).
•
Use blades that are not worn.
•
Adjust the blade-length and FORCE settings until only traces of the blade are left on the backing sheet.
Specify a FORCE value that is as low as possible, but that still leaves faint traces on the backing sheet.
•
Set the SPEED and ACCELERATION values as low as possible.
<Supplement>
Weeding refers to the removal of unwanted areas from the background after the media has been cut.
Supplement
•
Completion will become coarser, but the cut time is decreased when the settings for the speed and acceleration is set higher.
Especially with the large media, good cut quality might not be achieved by rumbling media. Decrease the values for the speed and
acceleration settings in that case.
•
Completion will become good, but the cut time will increase when the settings for the speed and acceleration is set smaller.
2-59
Advertisement
Table of Contents
