GRAPHTEC LABERLROBO DLC1000 User Manual page 152

LCD Display Cause
The load to cross cut unit is large,
and the current to the motor
The separator (weeding) is not
separating.
The load to winding motor 1 is
large, and the current to the motor
The load to winding motor 2 is
large, and the current to the motor
The load to winding motor for
laminate backing sheet is large, and
the current to the motor exceeds
Since the winding amount of the
separator (weeding) became thick
(Scrap amount was increased), the
separator can no longer be rotated.
The load to separator (weeding)
motor is large, and the current to
The cutter unit is not turned on.
The cable connected to the cutter
unit is disconnected.
(Internal or communication error
occurs, rather than the above
cause) when this error frequently
occurs, please contact the
distributor where you purchased
this product or your nearest
Graphtec vender.
6-6
Solution
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
If the media is not separated (weeded), the
cross cut cannot be performed well.
Separate the media properly.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Replace the bobbin wound the media with the
new one.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Check the data.
Check the power cable, power switch, and
connection cable in the cutter unit.
Please contact the distributor where you
purchased this product or your nearest Graphtec
vender.