GRAPHTEC LABERLROBO DLC1000 User Manual page 110

Table of Contents

of raster line..........

Previewing

the cut line ............ Used to select whether or not to preview the cut line.

Restore Defaults ......... Restores the set value to the initial value.

.....

lines.

them as Cutlines and they will not be output. If you want to output

such lines as Cutlines, check this box.

Line Length ..........

The driver ignores lines which are shorter than this length, and does

not output them.

The settings range is 0.1 mm - 5.0 mm.

Treat as same

line if gap is ..........

Depending on the application used, gaps can occur in an output

enables output as one continuous line. However, if this value is too

large, separate lines may be treated as one continuous line.

The settings range is 0 to 20 dots.

3-6

Table of Contents

Need help?

Do you have a question about the LABERLROBO DLC1000 and is the answer not in the manual?