Table of Contents
Advertisement
6
setting menu without cutting with adjustment patterns. (The
screen goes to "Numerical entry of registration mark position
adjustment").
position (Registration Mark 1) is sensed and the media is cut
(20×20mm)
Check this cut position (deviation volume) and then go to
"Numerical entry of registration mark position adjustment".
Numerical entry of registration mark position adjustment
Correct rectangle position
7
Perform the numerical entry of registration mark position
adjustment.
SENSOR OFFSET ADJUST screen is displayed.
The range of X and Y are -3.0 to +3.0 mm.
When the inch unit is used, adjust the position of registration
mark sensor by setting both X and Y to the range of -0.118 to
0.118 inches.
Registration Mark 1
(Dashed line)
Actual cut
(Solid line)
Media feeding direction
Push roller
Registration Mark 1
Media feeding direction
Push roller
4-15
Advertisement
Table of Contents
