Setting The Rewind (Rewind) - GRAPHTEC LABERLROBO DLC1000 User Manual

Setting the Rewind (REWIND)

Set whether or not to use the rewind function.
When set to "ON" (used), the motor rotates when setting the winder bobbin in the winding part and the label is rewound.
CAUTION
•
When the slitter is used, the media must be weeded.
•
The slitter is used to cut the backing sheet of label material that has been weeded. The label material with the backing sheet or label
that stuck a laminate material may not be cut completely. At this time, the glue of the label material is attached to the blade, or the
failure of the cross-cut section may be caused. Please do not cut other than the backing sheet.
•
When set to "ON" (used), the rewind function is disabled automatically.
Operation
1
CUT CONDITION & TEST screen is displayed.
2
Press the POSITION (
CONDITION (The selected item is highlighted.). Then, press
Cond No. selection screen is displayed.
3
Press the POSITION (
LABEL.
4
Press the POSITION (
(not used) for the REWIND.
5
Setting will be set, and it will return to CUT CONDITION & TEST screen.
6
It will return to READY screen.
) keys to select the CUT
) keys to select the REWIND
) keys to set to "ON" (used) or "OFF"
2-66