GRAPHTEC LABERLROBO DLC1000 User Manual page 7

Do not attempt to lubricate the machine's
mechanisms.
•
Such action may cause it to break down.
Prohibited
Do not place the machine on an incline, areas
subject to many vibrations, or other unstable
locations.
•
If the machine falls, it may cause human injury.
Prohibited
Move the pen carriage slowly when moving it
manually in order to load the medium or for other
reasons.
•
Moving it quickly may damage the machine.
Run a test cut when cutting materials with unknown
condition settings.
•
Running a cut operation with incorrect setting values may
cause a large overload to the blades and device or a system
breakdown.
Safety Precautions
CAUTION
v
that the media does not strike any objects in the
•
Such contact may cause cutting to go out of alignment.
No touching
When using the cutter pen, take care not to extend
the cutter blade excessively.
•
An excessive blade length will damage the cutting mat and
impair the machine's cutting quality.
lamps and desk lamps, make sure the machine is
separated by at least 1 m.
•
Placing the machine too close to such lighting may cause
sensor malfunctions and the paper detection to not function
Before use, check that the power can be turned off
by pressing the Emergency Stop Switch.