Table of Contents
Advertisement
Cutter unit
(6) Grit roller position guide
(7) Cutting mat
(1) Push roller ...........................This is used to press the media against the grit roller.
(2) Media sensors .....................The front sensor is used to sense the leading edge of the media. The rear
(3) Set lever ..............................When loading the media to the cutting part, raise and lower the push roller to
(4) Tool holder ..........................Holds the cutter-pen or plotting pen and moves it up or down.
(5) Tool carriage .......................Moves the cutter-pen or plotting pen across the media during cutting.
(6) Grit roller position guide ......Stickers on the front of the Y rail and the rear side of the top cover that show
(7) Cutting mat .........................Cutter blade moved on this mat, preventing wears of the blade.
(8) Grit rollers ...........................This is used to feed the media back and forth.
(9) Control panel (Cutter unit) ...This is not used in this Cutter.
(5) Tool carriage
(1) Push roller
(8) Grit rollers
sensor is used to sense the trailing edge of the media.
the position of each grit roller. To move the push roller, set it within the area of
this guide in accordance with the width of media.
* Leftmost position of the roller is not used.
(9) Control panel
(Cutter unit)
(4) Tool holder
(3) Set lever
(2) Media sensors
1-6
Advertisement
Table of Contents
