Error Messages - GRAPHTEC LABERLROBO DLC1000 User Manual

6.2

Error Messages

When the following error messages are displayed, turn off the power, and turn the power on after the error has
been solved.
LCD Display Cause
The dancer roller 1 is not set.
(Rather than the above cause) when
this error frequently occurs, the
dancer roller failure is considered.
The dancer roller 2 is not set.
(Rather than the above cause) when
this error frequently occurs, the
dancer roller failure is considered.
A paper jam occurs in the cutter
part.
Perforated to media, Media is
deviated from the path, or Media is
Mark is not printed in black on a
white background, or is faded.
Media is set in a deviated state and
the mark is out of the search range.
(Rather than the above cause) when
this error frequently occurs, the
dancer roller failure is considered.
Mark is not printed in black on a
white background, or is faded.
Media is set in a deviated state and
the mark is out of the search range.
(Rather than the above cause) when
this error frequently occurs, the
dancer roller failure is considered.
The load to cutter unit is large, and
the current to the motor exceeds
The condition setting of media to be
cut is not appropriate.
Something is hitting the tool
carriage.
External force was applied to the
tool carriage.
Scraps of the medium in the
cutter's moving parts are impeding
operation.
When this error frequently occurs, please contact the distributor where you purchased
this product or your nearest Graphtec vender.
6-5
Solution
Set the dancer roller 1.
Please contact the distributor where you
purchased this product or your nearest Graphtec
vender.
Set the dancer roller 2.
Please contact the distributor where you
purchased this product or your nearest Graphtec
vender.
Re-set the media properly.
Identify the cause related to media and set the
correct media.
Check the print status of mark.
Re-set the media.
Please contact the distributor where you
purchased this product or your nearest Graphtec
vender.
Check the print status of registration marks.
Re-set the media.
Please contact the distributor where you
purchased this product or your nearest Graphtec
vender.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Reduce the cut speed and acceleration.
Reduce the cutting pressure (FORCE).
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.
Remove the factors that interfere with the
operation and turn off the power then turn on
again.