Setting Interface; Usb Interface; Network (Lan) Interface - GRAPHTEC LABERLROBO DLC1000 User Manual

5.1

SETTING INTERFACE

This section will explain how to program the interface.
There is a USB/network (LAN) interface in this machine, and each switch will run automatically.
The interface setting is needed only when connecting with a network (LAN) cable.
It is not needed when connecting with a USB cable.
When using this machine, it will be necessary to install the driver software in your computer. Refer to "Setup
Manual" regarding installing the driver software.

USB Interface

When using the USB interface, make sure the driver software is installed in your computer.
CAUTION
Operation cannot be guaranteed in the following cases:
•
When connection has been made to a USB hub or an add-on USB board
•
•
When a driver other than the one provided was used
Cautions when USB 3.0 interface is used:
•
Note that some personal computer equipped with the USB 3.0 interface may not be backward-compatible with USB2.0 interface.
Be sure to observe the following:
•
Do not connect or disconnect the USB cable while you are installing the USB driver
•
Do not connect or disconnect the USB cable while starting up the computer or the printer. Do not disconnect the USB cable within a
5-second period of connecting it.
•
Do not connect or disconnect the USB cable while data is being transferred. Do not connect our multiple products to a single
computer.

Network (LAN) Interface

When using the network (LAN) interface, complete the machine settings such as your computer and network hub.
disconnect the network from the Internet.
CAUTION
•
A network (LAN) cable or network hub is needed in order to connect to the landmarked separate preparations.
•
your device's manual, or contact the manufacturer or network administrator for details.
•
5-2