Table of Contents
Advertisement
(11) Laminate holder
(12) Laminate winder bobbin
(13) Stand
(1) Power switch .......................Switch for turning the power on/off.
(2) AC line inlet .........................Connector that connects the power cord.
(3) Roll holder (1 and 2) ...........Use the Flange A and Flange B to align the roll paper in the proper position.
(4) Winding stocker cover (1 and 2)
.........................................This is used to protect the location to set the roll holder.
(5) Slitter unit ............................This is used to width-cut (longitudinal cut) the roll paper.
(6) Cross cutter unit ..................
(7) Ejection roller ......................The media is pressed against the lower roller and is fed.
(8) Separator unit ......................Set when unnecessary media is detached.
(9) Dancer roller 1 ....................Used when setting/feeding media.
(10) Emergency Stop Switch
.........................................Press to stop the machine. Please use this in case of emergency.
(11) Laminate folder ..................Sets the laminate.
(12) Laminate winder bobbin ....Rolls up the laminate backing sheet.
(13) Stand .................................A stand to put the machine on.
(14) Stand opening ....................Unnecessary media edge that was cut in the slitter enters in the stand through
(10) Emergency Stop Switch
(9) Dancer roller 1
(Winding part)
the bottom of this Cutter.
If necessary, please prepare the receiving box such as a paper box, etc.
1-4
(8) Separator unit
(7) Ejection roller
(6) Cross cutter unit
(5) Slitter unit
(4) Winding stocker cover 1
(3) Roll holder 1
(4) Winding stocker cover 2
(3) Roll holder 2
(1) Power switch
(2) AC line inlet
(14) Stand opening
Advertisement
Table of Contents
