Cable Clips - Thermo Scientific thermoscientific Vanquish UHPLC System Operating Manual

5 • Installation
5.4.4

Cable Clips

Page 60
The cable clips can be used to guide signal and power cables in an
orderly fashion. The pump and the detector each have one cable clip on
each side and the autosampler has two cable clips on each side. The
location of the cable clips/cutouts for the cable clips is shown below.
Figure 15: Cable clips/cable clip cutouts in the autosampler and detector
If not already done, install the cable clips in the cutouts of the housing as
shown below.
Figure 16: Inserting a cable clip
To insert the cables into the clip, open the flap.
UHPLC System
Operating Manual