Thermo Scientific thermoscientific Vanquish UHPLC System Operating Manual page 53

5.4.1.3 Moving the System Stack after Installation
UHPLC System
Operating Manual
5. Lift the column compartment into vertical position.
6. To insert the holding knobs in the grooves on the mounting bar,
grasp the column compartment by its sides and slightly lift the
column compartment up.
Figure 9: Attaching the column compartment to the system stack
Moving the Vanquish system stack even over short distances on the
workbench can damage and impair the functionality of the system base.
Observe the following:
• Configuration with one column compartment:
Before moving the system stack, unlock the system base using the
locking tools. For details, see
(} page 61).
• Configuration with two or three column compartments or a Charger:
Before moving the system stack, have the mentioned modules
dismounted by a Thermo Fisher Scientific service engineer and then
unlock the system base. For details, see
(} page 61).
Unlocking the System Base
Unlocking the System Base
5 • Installation
Page 53