Signal Cable Connections - Thermo Scientific thermoscientific Vanquish UHPLC System Operating Manual

5 • Installation
5.4.2

Signal Cable Connections

5.4.2.1
Connector Overview
Page 54
This section provides details on the cables and interfaces used to
connect the system to a computer or other devices, and details on how
to interlink the system modules with each other.
The following connectors are provided on the system modules for power
line connection and for signal connections:
Figure 10: Connectors (here: pump)
No. Description
1 System Interlink port
Allows power on/off control for the system from the Vanquish system base
and device communication
For details on system interlink connections, see
Connections (} page 57).
2 Digital I/O ports (not available in all modules)
Allow exchange of digital signals with external instruments
For information on connection and pin assignment, see the Operating
Manual for the related module.
3 USB (Universal Serial Bus) hub ("A"-type connector)
Allows connection to other modules in the Vanquish system
4 USB port ("B" type connector)
Allows connection to other modules in the Vanquish system or the
computer on which the data management system is installed, such as the
Chromeleon software
For details on USB connections, see
5 Main power switch (on/off control)
6 Fuse holder
7 Power inlet connector
System Interlink
USB Connections (} page 55).
UHPLC System
Operating Manual