Parts required
Tools required
Follow these steps
UHPLC System
Operating Manual
For installation of the standard configuration, follow the instructions
below.
•
4 T-slot nuts
•
2 crosspieces
•
4 screws
•
4 spacers
Screwdriver, Torx T20
1. Align the screw holes of the two T-slot nuts, the spacers and the
crosspiece.
Figure 7: Mounting bar
No.
Description
1
Spacer
2
Groove
3
Screw
4
T-slot nut
5
Crosspiece
2. With the screws, fix the T-slot nuts and the spacers onto the
crosspiece.
The T-slot nuts must face each other, as shown above.
5
•
Installation
Page 51