Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
•
Override is shared for all combined/uncombined rooms (when triggered
from master CLS-C6)
A CLS-C6 that is combined with another CLS-C6 that is, in turn, combined with a
third shall be considered combined with that third CLS-C6.
Example 1: Two Rooms
GLS-SIM
ID: 90
MASTER
Example 2: Three Rooms
GLS-SIM
ID: 90
MASTER
Example 3: One Small and one Large Room
GLS-SIM
ID: 90
MASTER
In example 3, above, since there are no partitions separating Slave 1 and Slave 2, or
Master and Slave 2, iLux Designer software must be used to indicate the default
status of these missing partitions. In this case, the following defaults should be set:
•
Master/Slave 1 default can be set to either Open or Closed, as the
physical partition sensor determines the actual state anyway
•
Master/Slave 2 default must be set to Closed since they are not directly
partitioned (we are assuming that Master and Slave 1 are separated by the
partition)
•
Slave 1/Slave 2 default must be set to Open since they are physically
located in the same room and thus must always be combined
Refer to iLux Designer help for more details.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 82
iLux Integrated Lighting System
Partition Sensor
Partition
Master/Slave 1
SLAVE 1
Partition Sensor
GLS-SIM
ID: 98
Partition
Master/Slave 1
M/S1
SLAVE 1
Partition Sensor
Partition
Master/Slave 1
M/S1
SLAVE 1
Partition
Sensor
Partition
Slave 1/Slave 2
S1/S2
SLAVE 2
SLAVE 2