Console Command Settings - Crestron iLux CLS-C6 Series Operation Manual

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
CLS-C6
The "CLS-C6" screen allows entry of the the manual ramp rate used by the CLS-C6
when manually raising/lowering light levels; define the functionality of the six
function buttons; define the behavior of the up/down button; specify if scene
raise/lower is enabled; and define the entry action, the exit action, and motion sensor
timeout when the motion sensor function is enabled. Crestron Engraver software can
also be launched to create an engraver project for the CLS-C6 label.
NOTE: In systems with multiple CLS-C6 units that have the motion sensor function
enabled, it is important to set the motion sensor timeout of each unit to the same
value.
Keypads
The "Keypads" screen allows up to 16 remote keypads to be added; specify the
remote keypad type; define the action type, action, and target of each button on that
keypad. Crestron Engraver can also be launched to create an engraver project for
each remote keypad.
NOTE: All keypads defined in the project must be installed and present on the
CLS-C6 network before setting Network IDs via the Finish screen.
Touchpanel
The "Touchpanel" screen allows up to two touch screens to be added, enter unique
names for the touch screen and buttons, and define the action type, action, and target
of each button on that touch screen.
NOTE: All touch screen defined in the project must be installed and present on the
CLS-C6 network before sending Touch screen projects or setting Network IDs via
the Finish screen.
Finish
The "Finish" screen allows the project to be sent from the iLux Designer project to
the CLS-C6; set the Net IDs for network devices; retrieve configuration information
from the current CLS-C6 module; and print reports that give the spreadsheet data
from each of the configuration screens.

Console Command Settings

Enabling/disabling IR reception, resetting the brightness level for the white and
green LEDs, and resetting the Glow mode level can be done only via console
commands.
By default, IR reception is enabled, the white and green LED brightness levels are
set to 70 and 63, respectively, the white shift LED brightness level is set to 70, and
the white LED Glow mode level is set to 7. If the settings are acceptable, continue
with the configuring procedures. If these settings are not satisfactory, open the
Crestron Toolbox and click Tools | Text Console to display the "Text Console"
window, and follow the instructions given below.
IR Reception
1. At the iLux> prompt, type <IR> and press Return to display the current
setting. The system displays:
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 25
iLux Integrated Lighting System