Crestron iLux CLS-C6 Series Operation Manual page 16

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
graph lights (and the display shows - -) to indicate that the level of the
lighting load does not change when that scene is recalled.
5. To change the shade presets for that scene press the Shades button; the
Shades LED lights.
6. Use the six function buttons to adjust the levels of the shade groups for that
scene. Press the right side to raise the shades; press the left side to lower
them. While the shades are moving, press any part of the button to stop.
Note that for shades that are not "presettable," only full open or full closed
positions can be recalled as part of a scene.
7. If there should be a certain shade group to be unaffected by that scene
recall, press and hold the center of the button (so both sides make contact)
for 3 seconds. The top two and the bottom two LEDs of the associated bar
graph lights (and the display shows - - ) to indicate that the level of that
shade group does not change when that scene is recalled.
8. To adjust the fade time, press the ^ and v buttons. When going up, the value
goes from 0 seconds to 59 seconds, and then 1 minute to 99 minutes. When
going down, the value goes from 99 minutes to 1 minute, and then 59
seconds to 0 seconds. The Min and Sec LEDs light as appropriate.
Adjustment to fade time can be made when either Lights mode or Shades
mode is active.
9. When all the lighting loads are at the desired level and shades are at the
desired position, press Save to save these settings as the new preset for that
scene. If a mistake is made while changing a setting, press Cancel to
discard changes and return to Standard mode before pressing Save.
10. Repeat the above procedures for all scenes that require changes.
Setup Mode
The Setup mode is used to change internal settings on the CLS-C6, including the
scene presets as discussed in the previous paragraph.
To enter Setup mode
•
seconds. The Cancel button LED blinks, and the first setup option (Sc)
displays, to indicate that the unit is now in Setup mode.
NOTE: While scrolling through the list of setup options, before an option
is "locked", the Save button is not functional and its LED is off. However,
the Cancel button LED blinks - since the button can be pressed to return the
unit to Standard mode.
• If the unit is connected to a Cresnet control system, Setup mode cannot be
entered to adjust scene settings. The two-digit display indicates "Er" (error).
When the unit is in Setup mode, the two-digit display uses a two-character
•
mnemonic to indicate which specific aspect of the CLS-C6 is changed. As
these are being adjusted, the display may indicate values. The following is a
list of the different Setup modes, and the corresponding mnemonic codes.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 12
iLux Integrated Lighting System
press and hold the Save and Cancel buttons for 5
,