Crestron iLux CLS-C6 Series Operation Manual page 38

Crestron CLS-C6/C6M & CLSI-C6/C6M
Scene Presets With Daylight
Harvesting
If a photocell is present, Scenes 1
through 8 (plus the ON scene)
automatically utilize Daylight
Harvesting. When this automatic
behavior is enabled, the topt bar
graph LED for that load blinks.
NOTE: When editing scenes with
photocell-controlled loads, photocell
output is temporarily disabled.
When the scene is recalled,
photocell control resumes and light
levels may change. To reduce the
possibility of unintended scene
behavior caused by photocell
reaction to sunlight, edit scenes at
night.
Operations Guide – DOC. 6347E
may be specified. (Refer to "Configuring With iLux Designer" on page 23 for
details.)
• Recall-scene (specify scene number OFF, ON, 1-15). Refer to "Recall-scene
buttons" below.
• Toggle-scene (specify scene number ON, 1-15). Refer to "Toggle-scene
buttons" on page 35.
Lighting master raise/lower (last scene). Refer to "Master (Last Scene)
•
Raise/Lower buttons" on page 35.
• Lighting master raise (last scene). Refer to "Lighting Master (Last Scene)
Raise buttons" on page 35.
• Lighting master lower (last scene). Refer to "Lighting Master (Last Scene)
Lower buttons" on page 35.
• Shade control (open/stop/close/stop) (specify shade group: AL, 1-6). Refer
to "Shade Control (open/stop/close/stop) Buttons" on page 35.
Recall-Scene Buttons
Used to recall a scene, i.e., have the specified lighting loads and/or shade groups go
to their specified levels in the specified time. (Time only affects lighting loads; shade
time is function of the shade motor.)
• During scene recall, the scene LED flashes until all affected lighting loads
reach their target levels. After this, the LED remains on steady.
• Pressing a scene button while its LED is flashing performs a scene cut
(lights immediately go to target levels).
• When a scene is recalled, the two-digit display initially shows the fade time
of the scene, and then count down to 0 as the scene progresses.
• For the six dual buttons, if the Raise/Lower function is enabled on
Recall-scene buttons via the iLux Designer software, and a scene is selected
(LED on steady), the right and left sides of the function button can be used
to raise and lower all dimmable lighting loads contained in that scene.
• The ON button always acts as a recall scene button for the ON scene,
operating identically to other scene-recall buttons, except that items specific
to dual buttons do not apply.
The OFF button always acts as a recall scene button for the OFF scene,
•
operating identically to other scene-recall buttons, except:
⇒ There is no LED associated with this button. Note that "cut" during
fade still functions. Note also that a feedback LED for an OFF button
on remote keypads acts as all other scene recall LEDs – it flashes while
the off scene is being recalled, and is lit when the unit is in the OFF
scene.
⇒ Items specific to dual buttons do not apply.
⇒ Note that if the last scene recalled was the OFF scene, the last scene
master affects all dimmable lighting channels (since they are all
included in the "last scene").
⇒ Any time all six lighting loads are off, all seven of these LEDs glow at
a low intensity (to allow finding the CLS-C6 unit in the dark).
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 34
iLux Integrated Lighting System