Crestron iLux CLS-C6 Series Operation Manual page 20

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
Setup High-End Levels (HE)
This option allows setting of the "full on" level of the lighting loads below their
maximum brightness. To set the high-end levels for the six lighting loads:
• Enter Setup mode and scroll to the "HE" option (using the ^ and v buttons).
At this point the lights do not change, but the bar graphs immediately
indicate the high-end levels for each lighting load. (In most cases this is
100%, which is indicated by all bar graph segments being on.)
• To set the high-end level, use the rocker button corresponding to that
lighting load to adjust it up or down. When the first adjustment is made, the
light being adjusted jumps to the current high-end level, and start adjusting
from there. As adjustments are made, the current light level for the lighting
load being adjusted should appear in the bar graph and the two-digit
display.
• The high-end level cannot be adjusted below 67%.
NOTE: For non-dim and "unused" lighting loads, the high-end level cannot
be adjusted (always at 100%). If adjusting this, the light and bar graph do
not change, and the two-digit display shows "Er" to indicate an error.
If setup is exited without pressing the Save button, the original values are retained.
For lighting loads where adjustment has been made, lights jump to the original high-
end level. Light levels are not change on lighting loads where no adjustment was
made. When the Save button is pressed, Setup mode is exited, the new values are
saved, and the lights do not change.
Setup Button Functions (bF)
This Setup mode is used to define the behavior of the buttons on the CLS-C6 unit
itself, and on remote keypads if operation is desired other than the default. (Remote
keypads must be ID'd, using auto-discovery, prior to this, which sets them to their
default functions.) To enter this mode:
• First enter Setup mode and scroll to the "bF" option (using the ^ and v
buttons). Then use the up/down button to scroll through the available button
functions and values. This scrolls through all values for each function
before proceeding to the next function.
• Press and hold the button to auto repeat. During auto-repeating, when it
reaches the minimum or maximum value for that function, it stops. The next
button push then increments/decrements to the next function.
Available functions and values are as shown in the following table. (Other
functions require a PC with iLux Designer software to configure them.)
BUTTON FUNCTION
Recall Scene
Toggle Scene
Control Shade
(open/stop/close/stop)
Master Raise/Lower (last scene)
1. To assign a function to a certain button or buttons, first scroll to the
desired function and value. Then, press each appropriate function
button or remote button to assign the displayed function and value to
that button.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 16
iLux Integrated Lighting System
CODE POSSIBLE VALUES
F1 oF,on,1-15
F2 on,1-15
F3 AL, 1-6
F4 uP, dn, ud (rockers only)