Crestron iLux CLS-C6 Series Operation Manual page 81

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
Function name Toggle-Dim Scene (on, 1-15)
Behavior Similar to the "Toggle Scene" function, except that a maintained press
of the button causes the lights to enter "cycle-dim" mode. That is, all
lights programmed in the specified scene either raise or lower until the
button is released. (Behavior is the same as Raise Scene function.) A
subsequent maintained button press causes the lights to dim in the
opposite direction.
If the button is "tapped" instead of held down, it behaves identically to
the "Toggle Scene" function.
LED On when any light in scene is on
Applies To Remote Button
Rocker N/A
Behavior
Notes This function intended for use only on scenes that do not affect shades.
Function name Open Shades Full (All, Group 1-6)
Behavior Sends the specified shades to Full Open position.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes Shade commands with "All" parameter only affect all the shade groups
connected to the given CLS-C6 module. They do not pass from one
CLS-C6 module to another (either when directly connected or when
linked through a Cresnet system). If all shades are to open in a multi-
unit system, define a scene to do that.
Function name Close Shades Full (All, Group 1-6)
Behavior Sends the specified shades to Full Closed position.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes Shade commands with "All" parameter only affect all the shade groups
connected to the given CLS-C6 module. They do not pass from one
CLS-C6 module to the other (either when directly connected or when
linked through Cresnet system). If all shades are to close in a multi-unit
system, define a scene to do that.
Function name Stop Shades (All, Group 1-6)
Behavior Stops the specified shades at current position.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes Shade commands with "All" parameter only affect all the shade groups
connected to the given CLS-C6 module. They do not pass from one
CLS-C6 module to the other (either when directly connected or when
linked through Cresnet system). To accomplish this function for all
shades in a multi-unit system, use SIMPL programming.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 77
iLux Integrated Lighting System