Configuring The Cls-C6; Configuring With Front Panel Controls - Crestron iLux CLS-C6 Series Operation Manual

Crestron CLS-C6/C6M & CLSI-C6/C6M

Configuring the CLS-C6

Scene Presets With Daylight
Harvesting
If a photocell is present, Scenes 1
through 8 (plus the ON scene)
automatically utilizes Daylight
Harvesting. When this automatic
behavior is enabled, the top bar
graph LED for that load blinks.
NOTE: When editing scenes with
photocell-controlled loads, photocell
output is temporarily disabled.
When the scene is recalled,
photocell control resumes and light
levels may change. To reduce the
possibility of unintended scene
behavior caused by photocell
reaction to sunlight, edit scenes at
night.
Operations Guide – DOC. 6347E
The overall configuration of the CLS-C6 can be accomplished in two ways: using the
front panel controls, or using the supplied iLux Designer application software, which
can be downloaded from the Crestron Web site.
Configuring via the front panel controls is not as extensive as what can be done using
the iLux Designer, but permits basic functional setup without having to use a PC.
In addition, some aspects of the CLS-C6's operation can be modified only via certain
Crestron Toolbox console commands. (Refer to "Console Command Settings" on
page 25 for details. Refer also to "Appendix B: Console Commands" on page 54 for
details on all applicable console commands.)
NOTE: Toolbox does not distinguish between the CLS-C6/C6M and CLSI-C6/C6M
devices. All report as CLS units.

Configuring With Front Panel Controls

Temporary changes can be made to accommodate a particular circumstance, or
change scene presets and replace the originals, as described below. To make more
extensive changes in the configuration of the CLS-C6 without using the iLux
Designer software, use the "Setup Mode", as described beginning on page 12.
Temporary Changes/Adjustments
Temporary changes/adjustments to the lighting levels or shade presets can be
accomplished as discussed in "Lights Mode" on page 38 and "Shades Mode" on
page 39.
Changing Scene Presets
The CLS-C6 scene settings can be modified via the front panel controls without
having to use a PC. Changes to the lighting load levels and shade presets for one or
more scenes can be accomplished as follows:
NOTE: The iLux Designer or SIMPL Windows programs can lock a scene to
prevent it from being changed using the front panel controls. If an adjustment is
made to a scene that is, "Er" is displayed for 3 seconds. The scene remains in its
existing state.
1. In Standard mode, press the function button of the scene to be modify and
hold it for 5 seconds. (Make sure to press the center of the button so both
sides make contact.)
2. The two-digit display first counts down as the lighting loads fade to their
preset levels for that scene; it then begins flashing between Sc. and the
scene number; the Lights LED illuminate, and the Save and Cancel LEDs
flash.
3. Use the six function buttons to adjust the levels of the lighting loads for that
scene. Press the left side of the buttons to lower the lighting loads; press the
right side of the buttons to raise the lighting loads.
4. If there should be a certain lighting load to be unaffected by that scene
recall, press and hold the center of the button (so both sides make contact)
for 3 seconds. The top two and the bottom two LEDs of the associated bar
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 11
iLux Integrated Lighting System