Crestron iLux CLS-C6 Series Operation Manual page 71

Crestron CLS-C6/C6M & CLSI-C6/C6M
Scene Programming
Commands
Operations Guide – DOC. 6347E
XX = ON, 1 - 15 Scenes
Scene Turn Off Lights Command
The following command is used to turn off scene lights:
Syntax: [ILUX] SC [XX] OFF
XX = ON, 1 - 15 Scenes
Scene State Query Command
The following command is used to read scene states. This command is not supported
for slave CLS-C6 devices.
Syntax: M SC [XX|ALL] STATE ?
XX = OFF, ON, 1 - 15 Scenes
Reply packet
M SC [XX] STATE [S]
S = 1/0 Scene state (1 means scene selected, 0 means scene not selected)
M SC [ALL] STATE [MASK]
MASK = Bit mask Bit0 - Bit16
(Bit0 = off scene state, Bit1 = On scene state,
Bit2 - Bit16 = Scene1 - Scene15)
Scene Quick Save Command
This command is used to save current light levels for selected scene:
Syntax: [ILUX] SC [XX] SAVE
XX = ON, 1 - 15 Scenes
Scene Query Light Zone Level Command
This command is used to read light level in scenes. This command is not supported
for slave CLS-C6 devices.
Syntax: M SC [XX] LZLVL ?
XX = OFF, ON, 1 - 15 (Scenes)
Reply packet
M SC [XX] LZLVL [LEVEL1] [....] [LEVEL6]
LEVELx = 0 - 100 for light zone1 through light zone6
Scene Query Shade Group Level Command
This command is used to read shade level in scenes. This command is not supported
for slave CLS-C6 devices.
Syntax: M SC [XX] SZLVL ?
XX = OFF, ON, 1...15 (Scenes)
Reply packet
M SC [XX] SZLVL [LEVEL1] [....] [LEVEL6]
LEVELx = 0 - 100 for shade zone1 through shade zone6
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 67
iLux Integrated Lighting System