Configuring With Ilux Designer - Crestron iLux CLS-C6 Series Operation Manual

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
Photocell Response Time (Pr)
This Setup mode is used to adjust the response time of the lights to a change in the
photocell reading. Valid values are 10 seconds, 30 seconds, 1 minute, 2 minutes,
5 minutes. The default value is 1 minute.
To adjust the response time of the photocell:
• Enter Setup mode and scroll to the "Pr" option (using the ^ and v buttons).
Press either the top or bottom portion of the raise/lower button. The 2-digit
display indicates the response time.
Use the ^ and v buttons (located next to save/cancel) to increase or decrease
•
the response time.
• Press Save to save the new setting or Cancel to retain the original setting.
NOTE: The CLS-C6 temporarily utilizes a faster response time when there
are rapid changes in light (such as when shades or blinds are opened or
closed). If daylight in the room has increased, the response time is increased
to 10 seconds. If daylight in the room has decreased, the response time is 2
seconds. Under normal operation, the CLS-C6 implements a gradual
response time.
Restore Factory Defaults (Fd)
This procedure is used to restore all settings to their factory defaults.
1. First enter Setup mode and then scroll to the "Fd" option (using the ^ and v
buttons). Then press the up/down button (either top, bottom, or both), and
hold for 5 seconds.
This procedure is locked in, and the Save LED flashes. (If the button is
2.
released before 5 seconds are up, nothing happens.) Press Save all
configuration items are set to their factory default values. (Press Cancel and
the unit exits Setup mode without changes.) The factory default
configuration does not include any remote devices. To re-initialize remote
devices, run Auto-discover after this function. Running the factory default
function does modify the MNET ID of the CLS-C6.
3. The save process may take a few seconds. During this time, the Save LED
is lit steady, and the two-digit display shows "—". When the process is
complete, the LEDs extinguish.
Refer to "Appendix C: RS-232 Commands" on page 58 for a list of the system
default values.

Configuring with iLux Designer

The Crestron iLux Designer program software supplied with all of the CLS-C6 series
units configures the CLS-C6 as an independent, standalone device or as a network
device in a Crestron network control system (Cresnet system).
To configure the CLS-C6 using the iLux Designer, use a direct serial connection as
described in "Establishing Communication" on page 31.
NOTE: Connecting the serial cable to the front panel of the CLS-C6 disconnects the
control system network.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 23
iLux Integrated Lighting System