Crestron iLux CLS-C6 Series Operation Manual page 83

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
Function name Open Momentary/Open Full (All, Group 1-6)
Behavior A quick tap of the button performs a "Full Open". A maintained press
performs a "Momentary Open" until the button is released.
If the shade is already moving in the open direction, a tap stops it. If the
button is tapped once, it starts moving to full open; then if tapped again,
it stops.
If the shade is moving in the close direction, a tap sends to full open. A
longer press performs a "Momentary Open" until the button is released.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes When changing direction, there may be a short time when the shade is
stopped before it starts moving in the opposite direction. This is the
"lockout time" for the shade controllers. This time is fixed for the
C2N-SSC shades; it can be changed for the SDC and SDC-DC
controllers via iLux Designer.
Shade commands with "All" parameter only affects all the shade groups
connected to the given CLS-C6 module. They do not pass from one
CLS-C6 module to the other (either when directly connected or when
linked through Cresnet system). To accomplish this function for all
shades in a multi-unit system, use SIMPL programming.
Function name Close Momentary/Close Full (All, Group 1-6)
Behavior Same as "Open Momentary/Open Full Shade Group 1-6", except Close.
LED On while button is pressed
Applies To Remote Button
Rocker N/A
Behavior
Notes Same as "Open Momentary/Open Full Shade Group 1-6."
Function name Open/Stop/Close/Stop (All, Group 1-6)
Behavior Function alternates between the "Full Open", "Stop" and "Full Close"
commands for the specified shade group(s) each time the button is
pressed.
LED On while button is pressed
Applies To Standard Rocker, Shifted Rocker, Remote Button, up/down (All only)
Rocker Pressing center of the button acts the same as non-rocker
Behavior open/stop/close/stop. Pressing only one side of the button while
stopped always send it in specified direction – rather than in opposite of
last direction. Pressing any part of the button while the shade is moving
stops it.
For up/down button
Notes Shade commands with "All" parameter only affects all the shade groups
connected to the given CLS-C6 module. They do not pass from one
CLS-C6 module to the other (either when directly connected or when
linked through a Cresnet system). To accomplish this function for all
shades in a multi-unit system, use SIMPL programming.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 79
iLux Integrated Lighting System
bottom button = left button => close.
top button = right button => open.