Crestron iLux CLS-C6 Series Operation Manual page 31

Crestron CLS-C6/C6M & CLSI-C6/C6M
Operations Guide – DOC. 6347E
To replace the label on the unit:
1. Remove the front panel assembly by carefully pulling out and up from the
bottom edge.
2. Carefully pull the label cover from the top edge at each side of the unit.
Refer to the following illustration.
3. Remove the original label and replace it with the new label.
4. Replace the label cover, make sure the small tabs on the bottom edge are
inserted in the slots on the unit cover, and snap into position.
5. Install the front cover assembly on the unit by lining it up at the top and
pressing the bottom edge until it snaps into position.
iLux Integrated Lighting System: CLS-C6/C6M & CLSI-C6/C6M • 27
iLux Integrated Lighting System