Lcd Display - YASKAWA HV600 Installation & Startup

4.2 Keypad: Names and Functions
No. Name
Left Arrow Key
Up Arrow Key/Down Arrow Key
/
H
Right Arrow Key (RESET)
ENTER Key
AUTO Key
I
J
USB Terminal
K RJ-45 Connector
L Clock Battery Cover
M Insulation Sheet
*1 Refer to AUTO LED and HAND LED Indications on page 75
◆

LCD Display

Symbol Name
A Time display area
B Forward/Reverse run indication
C Ready
74
Moves the cursor to the left.
• Scrolls up or down to display the next item or the previous item.
• Selects parameter numbers, and increments or decrements setting values.
• Moves the cursor to the right.
• Continues to the next screen.
• Clears drive faults.
• Enters parameter values and settings.
• Selects menu items to move the user between keypad displays.
• Selects each mode, parameter, and set value.
Sets drive operation to AUTO Mode.
The drive uses the b1-01 [Frequency Reference Selection 1] and b1-02 [Run Command Selection 1] settings.
Note:
Push on the keypad to set the drive to HAND Mode before you use the keypad to operate the motor.
Insertion point for a mini USB cable. Uses a USB cable (USB standard 2.0, type A - mini-B) to connect the keypad to a PC.
Uses an RJ-45 8-pin straight through UTP CAT5e extension cable or keypad connector to connect to the drive.
Cover for the clock battery.
Note:
• The battery included with the keypad is for operation check. It may be exhausted earlier than the expected battery life
described in the manual.
• Refer to "Maintenance & Troubleshooting Manual (TOEPYAIHV6001)" for more information about replacement
procedure.
To replace the battery, use a Hitachi Maxell "CR2016 Lithium Manganese Dioxide Lithium Battery" or an equivalent battery
with these properties:
• Nominal voltage: 3 V
• Operating temperature range: -20 °C to +85 °C (-4 °F to +185 °F)
An insulating sheet is attached to the keypad battery to prevent battery drain. Remove the insulation sheet before you use the
keypad for the first time.
for more information about AUTO LED and HAND LED indications.
Figure 4.2 LCD Display Indications
Table 4.2 LCD Display Indications and Meanings
Shows the current time. Set the time on the default settings screen.
Shows direction of motor rotation.
• FWD: Shown when set to Forward run.
• REV: Shown when set to Reverse run.
The screen will show Rdy when the drive is ready for operation or when the drive is running.
YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
Function
Description