Warning Labels - YASKAWA HV600 Installation & Startup

i.2 Using the Product Safely
Tighten terminal cover screws and hold the case safely when you move the bypass.
If the bypass or covers fall, it can cause moderate injury.
Use an inverter-duty motor or vector-duty motor with reinforced insulation and windings applicable
for use with an AC drive.
If the motor does not have the correct insulation, it can cause a short circuit or ground fault from insulation
deterioration.
When you touch the bypass, drive, and circuit boards, make sure that you observe correct
electrostatic discharge (ESD) procedures.
If you do not follow procedures, it can cause ESD damage to the drive and bypass circuitry.
Do not do a withstand voltage test or use a megohmmeter or megger insulation tester on the
bypass.
These tests can cause damage to the bypass.
Do not operate a bypass or connected equipment that has damaged or missing parts.
You can cause damage to the bypass and connected equipment.
Do not use steam or other disinfectants to fumigate wood for packaging the bypass. Use
alternative methods, for example heat treatment, before you package the components.
Gas from wood packaging fumigated with halogen disinfectants, for example fluorine, chlorine, bromine, iodine or
DOP gas (phthalic acid ester), can cause damage to the bypass.
◆

Warning Labels

The drive warning label is in the location shown in
The bypass warning labels are in the locations shown in
12
CAUTION
Crush Hazard
NOTICE
Damage to Equipment
Figure
Figure i.1 Drive Warning Label Content and Location
Figure
YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
i.1. Use the drive as specified by this information.
i.2. Use the bypass as specified by this information.