YASKAWA HV600 Installation & Startup page 297

A - Grounding surface (Remove any paint or sealant.)
B - Metal plate
C - Drive
D - Shielded wire
Ground Wiring
WARNING! Electrical Shock Hazard. Do not remove covers or touch circuit boards while the bypass is energized. If you touch the
internal components of an energized bypass, it can cause serious injury or death.
WARNING! Electrical Shock Hazard. Ground the neutral point on the power supply of the bypass to comply with the EMC Directive
before you turn on the EMC filter. If you turn ON the EMC filter, but you do not ground the neutral point, it can cause serious injury or
death.
Enable the Internal EMC Filter
Move the screws to turn ON and OFF (enable and disable) the EMC filter.
YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
E - Motor
F - Motor cable
G - Cable clamp
H - Grounding wire
Figure 9.5 Install a Drive with a Built-in EMC Filter
9.3 European Standards
297
9