YASKAWA HV600 Installation & Startup page 167

3.
Use the two screws included in the option kit to fasten the option card to the metal standoffs on the bypass
PCB. Use a short-shaft, magnetic screwdriver for narrow enclosure models H6BPxxxx. Tighten each screw to
0.5 to 0.6 N•m (4.4 to 5.3 in lbs).
4.
Firmly insert the end of the customer-supplied network cable into the CN1 connection port on the option
board. When you have a dual-port option, connect two network cables to the two network ports in CN1 for
flexibility in cabling topology.
Figure 6.3 Connect Network Cable to Option (SI-W3 LonWorks Example)
YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
CN5
Figure 6.2 Insert Option into Bypass PCB CN5 Connector Port
6.6 Peripheral Devices and Options
6
167