Temporary Needle Bar Setting; Uninterrupted Embroidering (Monochrome) - Brother PR670E Operation Manual

Temporary Needle Bar
Setting
After embroidering begins, the machine can be
stopped at a color change and a different needle
bar can be specified for the next color to be sewn.
By substituting an upper thread color already
threaded on a different needle bar, the time for
sewing can be saved. For example, similar color
thread can be substituted for temporary use.
a Touch .
 The temporary needle bar setting screen appears.
b Touch the key for the needle bar threaded
with the thread that you wish to embroider
with.
 The needle bar number changes and
indicate the selected needle bar.
 To cancel the setting, touch
c Touch .
 The embroidering screen appears again.
Uninterrupted embroidering
(monochrome)
A selected pattern can be stitched out in one color
instead of multicolor. The machine will hesitate
but not stop between color steps, and then
continue till the pattern is completed.
Touch the key for the needle bar threaded
a
with the thread you wish to embroider
uninterruptedly.
b Touch
become shaded and the selected pattern
will embroider in a single color, instead of
changing the thread while embroidering.
appears to
.
 The thread color displayed on the screen will be
• Touch
EMBROIDERING SETTINGS
Memo
• The thread color (needle bar) cannot be
changed in the middle of an area that is
being sewn.
for the multicolor steps to
grayed out.
again to return to the pattern's original
settings.
Memo
• Even if uninterrupted embroidering has
been set, the DST thread trimming function
can be used (refer to page 184).
• After finishing the embroidery, uninterrupted
embroidery will be canceled.
4
119