Table of Contents
Advertisement
USING THE CAMERA TO CONNECT PATTERNS
Message appears on screen and carriage will move
after pressing
w
Lower the embroidery foot, and then
embroider the third pattern.
When embroidering is finished, the following
message appears. When finished connecting
patterns, press
After embroidering is finished,
located at the top left of LCD screen.
The three patterns have been connected.
Changing the Position of a Sticker
If the selected pattern or embroidery positioning
stickers for connecting the next pattern do not easily fit
in the embroidering area, follow the on-screen
instructions that appear after step
order to move the embroidery positioning stickers.
For an example, the on-screen instruction appears
when you use the embroidery frame with a size of 10
cm × 10 cm (4 inches × 4 inches) to connect patterns as
shown below.
a Pattern A
b Pattern B
142
.
.
is no longer
o
on page 139 in
a
a
Refer to steps
through
"Connecting Three Patterns" using the
embroidery frame with a size of 10 cm × 10
cm (4 inches × 4 inches) to embroider the
first pattern and to connect the second
pattern.
b
Following message appears in step
next pattern or affixed embroidery
positioning stickers are close to being out of
the embroidering area. Follow the
instructions and then press
a Embroidering area
o
of
p
if the
.
a
Advertisement
Table of Contents
