Sewing Speed Controller (For Models Equipped With The Start/Stop Button); Changing The Needle Stop Position; Changing The Initial Needle Position - Brother 888-E44 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Sewing speed controller
(for models equipped with
the start/stop button)
Slide the sewing speed controller to the left or
a
right to select the desired sewing speed.
Slide the sewing speed controller to the left to
sew at a slower speed, or slide the speed
controller to the right to sew at a faster speed.
a Sewing speed controller
• The speed set using the sewing speed
controller is the foot controller's maximum
sewing speed.

Changing the needle stop position

Normally, the sewing machine is set to leave the needle in
the fabric when sewing is stopped. Instead, the machine can
be set to leave the needle raised when sewing is stopped.
Turn off the sewing machine.
a
Hold down the "–" side of
b
key) on the left and turn on the sewing machine.
After turning on the sewing machine, release
the "–" side of

The needle stop position changes to the
raised position.
Memo
• Perform the same operation to change the
needle stop position to the lowered position.
(stitch selection
(stitch selection key).
Changing the initial needle
position
Normally, the straight stitch (left needle position) is
automatically selected when the sewing machine is
turned on. The machine can be set so that the
straight stitch (center needle position) is
automatically selected when it is turned on.
Turn off the sewing machine.
a
Hold down the "+" side of
b
key) on the left and turn on the sewing
machine.
After turning on the sewing machine, release
the "+" side of (stitch selection key).
 The initial needle position changes to
the center needle position.
Memo
● The specified initial needle position is
maintained even after the machine is turned
off.
● Perform the same operation to change the
initial needle position to the left needle
position.
1
(stitch selection
15