Connecting The Power Supply And Battery Charger; Charging The Prosthesis Battery; Charging The Remote Control Battery - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

6.1 Connecting the power supply and battery charger

1) Slide the country-specific plug adapter onto the power supply until it locks into place.
2) Connect the round, three-pin plug of the power supply to the 12V receptacle on the battery charger so that the
plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
3) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery charger so that
the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger light up.
→ If the green LED on the power supply and the green LED on the battery charger do not light up, there is an
error (see Page 91).

6.2 Charging the prosthesis battery

6.3 Charging the remote control battery

1) Open the charging receptacle cover of the remote control unit.
2) Plug the charging cable into the charging receptacle of the remote control until the plug connector of the char­
ging cable snaps into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting the cable plug
to the charging receptacle of the remote control.
3) Plug the power supply into the socket.
C-Leg 3C98-3/3C88-3
1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the product.
INFORMATION: Take note of the plug direction!
→ The correct connection of the battery charger to the product is indicated by
feedback (see Page 93).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the battery
charger turns off.
4) Disconnect the product after the charging process is complete.
→ This is followed by an electronics self-test which is confirmed by feedback
(see Page 93).
5) Close the charging receptacle cover.
Charging the battery
Ottobock | 63