Introduction - Siemens SIRIUS M200D Manual

Functions

3.2 Introduction

Device functions for the M200D AS-i Standard starter
Additional functions
Emergency start (Page 76)
Self-test (Page 77)
Factory settings (Page 78)
Main power monitoring (Page 80)
Cold run (Page 82)
Local device interface (Page 83)
Integrated manual local control
(key-operated switch, keypad with LEDs)
Setting elements for parameter assignment on device
● Integrated
○ Order variant
The AS-i Standard starter has two AS-i slaves and therefore occupies two AS-i addresses.
1)
3.2 Introduction
Device function
This section describes the device functions. All the device functions are assigned inputs (e.g.
device parameters) and outputs (e.g. messages).
The following schematic diagram illustrates the functional principle of the device:
Figure 3-1
Further details regarding device parameters and their change options can be found in the
chapter entitled Parameterizing (Page 115)
24
Functional principle of the device
Electromech. Electronic
(DSte, RSte) (sDSSte, sRSSte)
●
●
●
—
●
●
○
—
M200D AS-Interface Standard
Manual, 08/2014, A5E02548958A/RS-AA/004
●
●
●
●
●
●
○
—