Siemens SIRIUS M200D Manual page 121

Process image for ID1 = 5:
Byte/bit
DI 0
DI 1
DI 2
DI 3
Note
The cyclic process data that is assigned depends on the ID1 setting for Slave 2. You can
change the ID1 code using the addressing unit or the Motor Starter ES software.
If you change it using the Motor Starter ES software, the cyclic message data is changed
directly and the ID1 setting for Slave 2 is changed automatically within the slave.
If ID1 is changed, the new setting will only take effect following a restart.
Slave 1
Byte/bit
DI 0
DI 1
DI 2
DI 3
M200D AS-Interface Standard
Manual, 08/2014, A5E02548958A/RS-AA/004
Process image
Ready (automatic)
Group fault
Input 1
(input action: quick stop)
Input 2
(no action)
Process image
Input 3
Input 4
Reserved
Reserved
Configuring/assigning parameters
5.5 Process data and process image
Signal: 1 = HIGH, 0 = LOW
0: Starter not ready for host/PLC
1: Starter ready to be operated via host
0: No fault
1: Fault
0: Not active
1: Active
0: Not active
1: Active
Signal: 1 = HIGH, 0 = LOW
0: Not active
1: Active
0: Not active
1: Active
—
—
121