Led Display Combinations - Siemens SIRIUS M200D Manual

7.1.2

LED display combinations

You can detect certain faults/errors more accurately by looking at the combination of display
statuses.
Device status/mode
SF LED
Off
Off
Off
Off
Off
Off
Off
Off
Off
Device errors
Note
Acknowledging device errors
A device error can only be acknowledged by switching the power off and then on again.
If the error occurs again, however, the motor starter will need to be replaced.
SF LED
Red
Red
Red
M200D AS-Interface Standard
Manual, 08/2014, A5E02548958A/RS-AA/004
STATE LED DEVICE LED
Green Green
Off Green
Flashing green Green
Flashing green Green
Flickering green Green
Flashing yellow Green
Flickering yellow Green
Off Flickering red
Off Flashing green
STATE LED DEVICE LED
Red Red
Off Red
Off Off
7.1 Diagnostics with LEDs
Device status/mode
Motor ON; no fault/error
Motor ON; no fault/error
Motor in soft startup; no fault/error
(sDSSte, sRSSte only)
Motor in soft run-down; no fault/error
(sDSSte, sRSSte only)
Motor ON; input controls
Manual mode connection abort without reset to
automatic mode
Tripping by means of input control function
(e.g. quick stop)
Self-test in progress (can only be called via
Motor Starter ES)
No startup parameters received
Device error
Current flowing with no ON command
(e.g.: contactor welded, thyristor fused)
Electronics defective, self-test error
No connection with AS-i
Diagnostics
135