Functions
3.3 Basic functions / parameters
3.3.3
Protection against voltage failure
You use this device parameter to specify whether or not the overload message must be
retained after an electronics voltage failure:
● Overload
● No overload
Settings
Protection against voltage failure
Note
This parameter can only be set using Motor Starter ES.
3.3.4
Response to switching element supply voltage cut-off
With this parameter, you determine which message the motor starter is to output if the
supply voltage of the switching elements fails.
Settings
Response to switching element supply
voltage cut-off
28
Device parameter
Device parameter
Default setting
Yes
Default setting
Group fault
Manual, 08/2014, A5E02548958A/RS-AA/004
Setting range
Yes
•
No
•
Setting range
Group fault
•
Group fault only after ON
•
command
Group warning
•
M200D AS-Interface Standard