2.21.2.1 Exit Mode; Camera Settings - DPS Telecom NetGuardian 832A G5 User Manual

69
· Set the In-Facility Send Count between 1 and 3, determining how many times the NetGuardian will
attempt to send the broadcast.
For more information about the In-Facility Broadcast mode, see your Building Access 32 manual.

2.21.2.1 Exit Mode

Exit Mode allows users operating in In-Facility Broadcast mode to signal to the BAC that they are
leaving a facility, and that they would like to re-enable door violations, preventing others from taking
advantage of the time remaining on an in-facility broadcast to gain access to otherwise restricted areas.
To enable Exit Mode:
· Check the box associated with the ID of the Entry Control Unit(s) for which you wish to enable Exit
Mode. Users will end the In-Facility Broadcast with a successful login (keypad or proxy) at a door/
ECU with Exit Mode enabled.
· Make sure Direction Enabled is unchecked
Note: Doors with Exit Mode enabled cannot process entry requests.
For more information about In-Facility Broadcast mode, see your Building Access Controller 32 user
manual.
2.22

Camera Settings

The NetGuardian SiteCam provides users with live streaming video of their remote sites. The direct pan-
and-tilt features allows users to visually check the status of their sites from the convenience of their
desktop.
Use the following steps to configure your camera settings:
1. From the Edit menu select Camera, see Figure 2.40.
2. Refer to Table 2.K and enter the appropriate information in the Name, Description, IP Address,
and MAC Address fields.
Note: See Section "Monitoring Camera Activity" for camera viewing options.
3. Click Submit Data to save your camera configuration settings.
Fig. 2.40. View live streaming video of your remote sites via Web browser